| 7-1 Insulation Resistance (Unmated) | Between adjacent contacts and contacts and ground. | EIA 364-21C (Apply 100 Volts DC) | 100M minimum |
| 7-2 Low Level Contact Resistance | Initial for VBUS and GND contacts and all other contacts; delta 10m(Max) after test. | EIA 364-23b (100mA max., 20mV max. open circuit) | 40m(Max) initial; 10m(Max) delta after test |
| 7-3 Dielectric Withstanding Voltage | Between adjacent terminals. | EIA 364-20 (Subjected to 100VAC (RMS) for 1 minute) | There shall be no breakdown |
| 7-4 Contact Current Rating | VBUS pins, VCONN pin, and other contacts. Temperature rise not to exceed 30 C. | EIA 364-70 (Ambient temperature 25 C) | VBUS: 5.0A; VCONN: 1.25A; Others: 0.25A |
| Durability | Must meet criteria after cycle test. | EIA 364-09 (10000 cycles at 200 cycles/hour manually) | Contact resistance (40m > delta 10m), Insertion force (5N-20N), Extraction force (8N-20N), Visual inspection (no exposed base metal) |
| Cable Flexing | No discontinuity over 1 microsecond during flexing or physical damage. | EIA 364-41 (100 cycles in 2 planes, 120 degrees; x=3.7x cable diameter) | No discontinuity or physical damage |
| Cable Pull-Out | No discontinuity or physical damage. | EIA-364-38 (40N steady state axial load for 1 minute) | No discontinuity or physical damage |
| 4-axes continuity test | No discontinuity greater than 1s and no physical damage. | EIA364-18 (8N tensile force for 10 seconds, subject to 0, 90, 180, 270 directions) | No discontinuity > 1s, no physical damage |
| Temperature Life | Visual inspection, Test shall be done in sequences defined in EIA 364-1000.01. | EIA 364-17 (105C for 120 hours; 105C for 72 hours as preconditioning for EIA 364-1000.01) | Visual inspection |
| Thermal Shock | No evidence of any physical damage. | EIA 364-32 (10 Cycles -55C and +85C; mated connectors) | No physical damage |
| Salt Spray | 1).Shall meet visual requirement, show no physical damage. 2).Shall meet requirements of additional tests as specified in test sequence in Section 5. | MIL-STD-202F, Method 101D, Test Condition B (Subject mated connectors to 48 hours at 35C with 5% Salt-solution concentration) | Visual and additional tests per EIA 364-1000.01 |
