| RATING |
| Rated Value | | | DC 20V 3A |
| Operating Temperature Range | | | -30~80C |
| STANDARD ATMOSPHERIC CONDITIONS |
| Measurement & Test Conditions | (1) Temperature | | 5C TO 35 |
| (2) Humidity | | 45% TO 85% |
| (3) Pressure | | 86Kpa TO 106Kpa |
| MECHANICAL PERFORMANCE |
| Connection Force | 3 times insertion/disconnection using standard plug gauge | | 5-20Nf |
| Disconnection Force | 3 times insertion/disconnection using standard plug gauge | | 6-20Nf |
| Terminal Strength | 0.1N/m (1kgf/cm) static load for 1 min in any direction | No damage to terminal (cracks, looseness, play); Satisfy electrical and mechanical characteristics | |
| ELECTRICAL PERFORMANCE |
| Contact Resistance | Measured at small current (100mA), 1000Hz | | 40M |
| Insulation Resistance | Apply 500V DC for 1 min (between body/conductor, non-contact conductors, non-contact conductors when plug inserted) | | 100M |
| Dielectric Strength | AC 500V rms (50~60Hz) for 1 min, Trip current: 0.5mA (between body/conductor, non-contact conductors, non-contact conductors when plug inserted) | No insulation breakdown, arcing, etc. | |
| DURABILITY |
| Solderability Test | Terminal top dipped 1mm in solder bath (2505) for 50.5 seconds | (1) Solder wetting time 3 seconds
(2) Soldering area > 75% | |
| Resistance to Soldering Heat Test (Reflow) | Preheat: 180 (120s)
Peak Temp: 2605 ( 20s) | No deformation of case or excessive looseness of terminals; Satisfy electrical characteristics | |
| Resistance to Soldering Heat Test (Soldering Iron) | Bit Temp: 3305
Application Time: 30.5 seconds (no excessive pressure) | No deformation of case or excessive looseness of terminals; Satisfy electrical characteristics | |
| Humidity Test | Stored at 402, 90%-96% RH for 96 hours, then 1 hour at standard atmospheric conditions | No damage on appearance; Satisfy mechanical and electrical characteristics | |
| Heat Test | Stored at 702 for 96 hours, then 1 hour at room temperature | No damage on appearance; Satisfy mechanical and electrical characteristics | |
| Cold Test | Stored at -253 for 96 hours, then 1 hour at room temperature | No damage on appearance; Satisfy mechanical and electrical characteristics | |
| Life Test | (1) Connection/Disconnection: 10,000 cycles at 10-20 cycles/min under rating condition (non-inductive load)
(2) Connection/Disconnection: 10,000 cycles at 10-25 cycles/min without load
(3) Disconnection Force | (1) Contact Resistance 0.1
(2) Disconnection Force: 0.8-2.0N
(3) Satisfy mechanical and electrical characteristics | |
| Temperature Cycling Test | 5 cycles of specified conditions, then 30 min at room ambient | No deformation or cracks in molded part.
Insertion & Extraction Force: 3-20N
Contact Resistance: Max. 30M
Insulation Resistance: Min. 100 M
Dielectric Withstanding Voltage: 100VAC/min (between terminals) | |
| Cold & Heat Shock Test | 5 cycles of specified conditions, then 30 min at room ambient | No deformation or cracks in molded part.
Insertion & Extraction Force: 3-25N
Contact Resistance: Max. 30M
Insulation Resistance: Min. 100 M
Dielectric Withstanding Voltage: 500VAC/min (between terminals) | |
